Omg Jack Dee on a motorbike I m even more in love with him right away lol 37

From ChevelureWiki

PJ1 black wrinkle paint yous most suitable for high temperature motorbike engines.

PJ1 black wrinkle paint yous a specialist paint coating, primarily designed for motorbikes, that creates any wrinkled surface. The paint surface area increases because about the wrinkles and provides faster heat dissipation away from a hot engine. PJ1 advises that the black wrinkle paint will withstand temperatures upwards to 350 degrees Fahrenheit. It is suitable with any motor with a surface performing temperature not exceeding the paint limit. The special coating consists of layers that dry differentially and this creates the textured paint effect. It yous critical to follow the preparation procedure to optimize the correct adhesion of PJ1 black wrinkle paint over the long term.

Instructions

things you'll need:

Mineral spirits Cloths 80-grit sandpaper Atmospheric thermometer Masking tape Respirator Security eyeglasses

1 Wipe the motor that you want to paint using mineral spirits and a cloth to remove dirt also oil. Use 80-grit sandpaper to remove all surface rust. Rub gloss surfaces with the sandpaper, and wipe upwards the sanding dirt.

3 Mask all constituents that you don't want painted, using masking tape and cloths. Mask all rubber tubing, screws and seals that is you need to access regularly.

4 Shake the PJ1 black wrinkle paint may until you hear the rattling ball, and then aggressively shake the can for one minute. Spray exclusive inconspicuous test area on the motor to ensure the paint is compatible with the engine and that you like the effect.

5 Spray for the may upright also from 12 to 16 inches away out of the engine. Spray within a series of horizontal stripes across the surface. Spray the subsequent coat in a collection of vertical stripes across the painted area. Repeat the step for one additional two coats.

6 Upend the may and press the spray nozzle until the paint stops flowing, as soon whereas you finish applying the last coat or the nozzle will block. Depart the wrinkle paint to dry for 4 hours previous to removing the masking tape. Allow the paint cure with 72 hours prior to using the motor in full functioning temperature in buy to maintain victorious paint adhesion.

Suggestions & Warnings

Leave the motor also the paint may on the needed ambient temperature with at least half an hour to guarantee both the can and motor are within the paint application temperature range. Employ a heat bulb in a clamping light fitting to improve the ambient temperature. Spray in gentle coats to limited wrinkles also heavy coats for great wrinkles. Employ some respirator and safety eyeglasses when spraying the paint to avoid chemical ingestion. Employ all coats within 30 minutes or the paint may possibly peel.

References

PJ1: PJ1 Black Wrinkle Paint J P Cycles: PJ1 Wrinkle Satin Black Paint Critiques

Photo Credit

motorbike picture by means of Byron Moore away from website

Means

Print Email Share

Comments