He was hotboxin a cigarette hittin it like a fawkin roach clip 35

From ChevelureWiki

Automotive trailers must be wired to relay the very same warning signals seeing that the automobile that is towing the trailer. While smaller trailers may utilize a simple four-wire connection to the automobile , larger trailers (such like recreational cars) generally involve any added complex wiring system.

Often, a large trailer entails a seven-way (or seven-wire) plug to connect to the automobile electrical system.

Trouble: Moderately Challenging

Directions

Seven-way car-part trailer connector Electrical pliers Screwdriver Wire splice connector terminals Installed electronic trailer brake unit

1 Pull each about the wires apart on the car-part trailer connector. Loosen and remove the tail lamp housing screws and pull the tail lamp housings out of the automobile frame since if you are going to replace the tail lamp bulbs.

2 Slip the first splice connector over unique of the tail lamp ground wires. Insert the whitened wire from the trailer connector into the splice connector terminal and crimp the connector terminal on to the wire pair.

3 Slip the second splice connector over the electrical brake yield wire. Insert the blue wire away from the trailer connector to the splice connector terminal and crimp the connector terminal on to the cable set.

4 Slip the third splice connector over the tail lamp wire. Put in the green wire from the trailer connector into the splice connector terminal and crimp the connector terminal on to the wire pair.

6 Slip the fifth splice connector over the left turn indicate wire. Insert the red wire from the trailer connector into the splice connector terminal and crimp the connector terminal on to the wire two.

7 Slip the sixth splice connector over the right turn indicate wire. Put in the brown wire from the trailer connector into the splice connector terminal plus crimp the connector terminal on to the wire set of two.

8 Slip the seventh splice connector over the again-up light wire. Insert the yellow wire from the trailer connector into the splice connector terminal and crimp the connector terminal on to the wire pair.

Tips & Warnings

Each cable on the vehicle tail lamp assembly remains usually marked along with an adhesive flag at the base of the lamp housing. Various older vehicles conduct not have a rear "accessory" wire. Alternately, you may desire to connect this wire to the positive wire on the cigarette lighter port or power point.

References

Popular Mechanics: Wiring Your Trailer Hitch Access Connect: Trailer Wiring Diagrams

Picture Credit

train, trailer image by Greg Pickens from internet site

Print Email Share

Comments