Cuz ur the cigarette im the smoker We raise a bet cuz ur the joker 55
From ChevelureWiki
Automotive trailers must be wired to relay the very same warning signals as the automobile that is towing the trailer. While scaled-down trailers may use a effortless four-wire link to the car , larger trailers (like as recreational cars) typically require a more complicated wiring method. Routinely, a large trailer requires a seven-way (or seven-wire) plug to connect to the automobile electrical method.
Difficulty: Moderately Challenging Instructions
Seven-way car-part trailer connector
Electrical pliers
Screwdriver
Wire splice connector terminals
Installed web trailer brake unit
1 Pull each of the wires apart on the car-side trailer connector. Loosen and remove the tail lamp housing screws and pull the tail lamp housings out of the vehicle frame seeing that if you are going to replace the tail lamp bulbs.
2 Slip the initial splice connector above one of the tail lamp ground wires. Insert the bright cable out of the trailer connector to the splice connector terminal and crimp the connector terminal on to the wire set of two.
3 Slip the second splice connector over the electric brake output wire. Insert the blue wire away from the trailer connector into the splice connector terminal also crimp the connector terminal on to the wire pair.
4 Slip the third splice connector above the tail lamp wire. Insert the green wire away from the trailer connector into the splice connector terminal and crimp the connector terminal on to the wire twosome.
5 Slip the fourth splice connector above the rear "accessory" wire. Insert the black wire out of the trailer connector into the splice connector terminal plus crimp the connector terminal on to the cable pair.
6 Slip the fifth splice connector over the left turn signal cable. Insert the red wire from the trailer connector to the splice connector terminal also crimp the connector terminal on to the wire pair.
7 Slip the sixth splice connector over the right turn indicate wire. Put in the brown wire out of the trailer connector to the splice connector terminal and crimp the connector terminal on to the wire pair.
8 Slip the seventh splice connector over the back-up light wire. Insert the yellow wire from the trailer connector in the splice connector terminal also crimp the connector terminal on to the wire combine.
Each wire on the car tail lamp assembly yous usually marked with an adhesive flag at the base of the lamp housing.
Some older vehicles execute not obtain a rear "accessory" wire. Alternately, you may wish to connect this wire to the positive wire on the cigarette lighter port or power level.
